|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This comprehesive service maual was greatly appreciated, as was the digital download.
 ;
Good en helpfull black and white scanned Srfvice manual of the Philps D8444. Quick service and delivery
;
Scan was really good quality, easy to read, download easy
;
very good manual as always. easy to read, detailed and includes schematic
;
I'm very satisfied with your manual service. Your website made it easy to locate the correct manual. Also the quality is great and I never had a problem reading the fine details.
Thanks again.
Jeff Miller
JM Electronics
Reference Information
2-1-4 How to Connect X-5 chassis jig
1. Unplug the power cord from AC outlet. 2. Remove the deck ass�y from main PCB (See Page 4-4 of service manual). 3. To emulate the function of the sensors, plug the power cord to outlet with pressing SW711 on the function PCB (See diagram below).
The location of SVC OPTION(SW711) is same on the function PCB regardless of model.
Function (Component side) Note : After completing repairs, unplug and plug the power cord in order to reset. 4. Insert wafers of drum motor, capstan motor and loading motor on X-5 chassis jig into each of the connectors of deck ass�y, and then secure with three screws. 5. Solder the 3 leads of the jig cable to �SERVICE OPTION� on the main PCB. 6. Apply power to the function PCB. 7. Insert a test tape into the housing ass�y. 8. Simultaneously touch the start and end sensor LEDs on the PCB, so that the tape loads automatically. After the tape is loaded, all of the function buttons on the function PCB can be used. 9. If the test tape is ejected while the jig is in use, attempt to re-load the tape by simultaneously touching the start and end sensor LEDs.
2-2
Samsung Electronics
|
|
|
> |
|
