|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Great tape deck manual!
I'm very positively surprised, because it is a very long manual, lot of pages, drawings, diagrams, description of how to make the alignment and adjustment procedures.
It is as good as the old "Naka" manuals from the 1970's - if somebody have seen them, they know what I mean by that.
I recommend to buy this very much !
;
I am a vintage hifi collector. No way to fix that device without the appropriate service manual...thanks to your site I got it and every thing is easier now. I got the manual right after ordering: fast cheap accurate ... thank you
;
Wonderful job clear. Qick fantastic. These people are really good. If even a problem arise they are wonderful assisting you. These scheme is so net despite this is a very old TV. Thank you for everything!!!!!!!!
;
Detailed schematic diagram, manual for professionals
;
Good service manual,exploded view,adjusment and test point locations,head alignment,mechanical checks and adjusments,all perfect.
Alignment and Adjustments
1-2 Cassette Deck
1-2-1 To Adjust Tape Speed
Notes 1) Measuring tape: i)(Tapes recorded with 3kHz) MTT-111 (or equivalent) ii) MTT-5512 (or equivalent) 2) Connect the cassette deck to the frequency counter as in figure 1-4.
SPK OUT output Figure 1-4 Cassette Deck Frequency Counter
1-2-2 To Adjust PlayBack Level
Notes 1) Before the actual adjustment, clean the play/recording head. 2) Measuring tape : i) MTT-114(or equivalent 10kHz AZIMUTH control) ii) MTT-112(or equivalent) : 3) The cassette deck is connections as shown in figure 1-6.
Recording /Play head
AZIMUTH control screw Figure 1-5
SET
SPK OUT
VTVM
Oscilloscope
Step
Item
Pre-Setup Condition OUT
Pre-Setup 1) Deck 1:MTT-111 2) Press PLAY SW button 3) Deck 2:MTT-5512
To Adjust
Standard
Remark
(GND)
! Adjust Deck 1 Play Level
Turn URV1 to left and right FRONT PCB 3KHz Step Item Pre-Setup Condition SPK OUT (VTVM is 1 AZIMUTH connected to the scope) Pre-Setup After putting MTT114 into Deck 1 1)Press PLAY button. To Adjust
Figure 1-6
In Out
1
NOR SPEED Control
(connected to the frequency counter)
Standard Max output and same phase (both channels)
Remark After adjustment secure it with REGION LOCK.
1) Turn the control screw to as shown in Figure 1-5.
Adjust REC Bias Voltage
Step Item REC Bias Voltage Pre-Setup Condition Connect to DCW2 as in Fig.1-7 and read the VTVM. Pre-Setup Input MTT-5512 into Deck2,then press REC button. To Adjust L-CH;DSR2 and R-CH;DSR1 to the right and left. Standard Remark See diagram for adjustment location
@ Adjust Deck 2 Play Level
Step 1 Item AZIMUTH Pre-Setup Condition SPK OUT (VTVM is connected to the scope) Pre-Setup After putting MTT114 into Deck 2 1)Press PLAY button. To Adjust 1) Turn the control screw to as shown in Figure 1-5. Standard Max output and same phase (both channels) Remark After adjustment secure it with REGION LOCK.
1
6V
VTVM SET
Oscilloscope
IN
UCW2
Figure 1-7 Samsung Electronics 1-3
|
|
|
> |
|